Below the rear passenger speaker is an impact sensor for the airbag. Well, since i dont have the airbag anymore i figure i dont need this sensor either. Sensor, with harness. The harness runs to a connector behind the passenger side kick panel. So all thats eliminated now. I also wanted to do something with this. This is the power for the rear right speaker, plus the seatbelt switch. I de-loomed all of this, and followed it back to a harness connector near the p.brake pedal. I bypassed the seatbelt switch, because i dont need my truck to tell me to wear my seatbelt. Then i pulled the wires for the rear right speaker out of the harness and separated them. I rerouted them thru the dash, thru the passenger side kick panel and sill, back to the speaker. They are long enough in stock form that i dont need to extend them. Plus, now i dont have any exposed wires in the interior of the bronco. The front half of the interior is solid, no rust repairs required. In the rear half, ive begun stripping the seam sealer, and began rust repair. There are more holes than i anticipated, i think im up to 5 or 6 now. Ill post pics during the week as i begin to tackle each one. Comments are closed.
|
Categories
All
Archives
May 2022
|